New-england-arbors VA68111 User Manual download pdf (Page 3)

ST EP THREE

Set out both side panels (36” opening between inside of

posts)

Place the assembled arch over the side panels and push down until

the post tops bottom out inside the post caps. You will need a

helper for this step.

Fasten the assembled arch system to the posts by installing screws

into the two pre-drilled holes provided on the bottom of each

post cap.

The Athens Arbor

Connect Arch System to Side Panels

ST EP F OU R

www.edenarbors.com

Slide the four ground anchoring stakes into the bottom of

each posts until it bottoms out and secure with two screws,

one on the outer side and one on the inner side of the post

as shown.

Arbor Installation

Arbors must be well secured to prevent tipping over from wind load etc.

We have provided four ground anchors for securing the arbor

either into the

ground or a concrete footing. In some cases it may be

acceptable to secure the arbor to an existing structure such as a fence

post. If you are installing your arbor on concrete or a deck, see your

hardware store for the appropriate galvanized bracketing hardware.

Ground Stakes Installations

Insert the horizontal spindles into the posts in the ‘sandwich’

pattern as illustrated

Lay out the opposite post as illustrated and complete

the side panel by inserting it into the post.

Fasten the horizontal side panel rails at the intersection of each

post with 2 screws. This will stiffen your side panel.

Repeat for other side panel.

Front

Back

Front

Back

Front

Position Screws

Diagonally to

Each Other

36”

1 2 3 4

No comments

New-england-arbors VA68111 User Manual Page 3